mp series ? sip ssr ? ratings to 4a @ 280 vac or 3a @ 60 vdc ? triac (ac) or transistor (dc) output ? dc control ? normally open (ac or dc) or normally closed output (dc only) ? ce compliant to en60950-1 product selection control voltage 3a 3a 4a 3a 3-32 vdc mp120d3 MP240D3 mp240d4 mpdcd3 available options ac output specifications (1) description mp120d3 MP240D3 mp240d4 operating voltage (47-63hz) [vrms] 12-140 24-280 24-280 transient overvoltage [vpk] 400 600 600 maximum off-state leakage current @ rated voltage [marms] 5 5 5 minimum off-state dv/dt @ maximum rated voltage [v/sec] (2) 200 200 200 maximum load current [arms] 3 3 4 minimum load current [arms] 0.02 0.02 0.02 maximum surge current (16.6ms) [apk] 90 90 130 maximum on-state voltage drop @ rated current [vpk] 1.6 1.6 1.6 maximum i2t for fusing (8.3 msec) [a2 sec] 36 36 72 minimum power factor (with maximum load) 0.5 0.5 0.5 dc output specifications (1) description mpdcd3 operating voltage range [vdc] 3-60 maximum load current [arms] 3 minimum load current [arms] 0.02 maximum surge current for 1 second [adc] 5 maximum on-state voltage drop @ rated current [vpk] 1.5 maximum off-state leakage current @ rated voltage [ma] 1.0
input specifications (1) description ac output dc output dc output (-b) control voltage range 3-32 vdc 3-32 vdc 3-32 vdc must turn on voltage 3.0 vdc 3.0 vdc 1.0 vdc must turn off voltage 1.0 vdc 1.0 vdc 3.0 vdc nominal input impedance 1500 ohm 1500 ohm 1500 ohm maximum turn-on time [msec] 1/2 cycle 100 s 100 s maximum turn-off time [msec] 1/2 cycle 100 s 100 s general specifications description parameters dielectric strength, input/output/base (50/60hz) 4000 vrms minimum insulation resistance (@ 500 vdc) 10 9 ohm maximum capacitance, input/output 8 pf ambient operating temperature range -40 to 80c ambient storage temperature range -40 to 125c weight (typical) 0.7 oz. (20g) encapsulation thermally conductive epoxy general notes 1) all parameters at 25c un less otherwise specified. 2) off-state dv/dt test method per eia/narm standard rs-443,13.11.1 3) inductive loads should be diode suppressed mechanical specifications
wiring diagram thermal derate information agency approvals designed in accordance with the requirements of iec 62314 en60950 : meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7: e116950 lr81689 (ac output only) 5900 ug (ac output only) rev. 011713
annex - enviromental information
|
